Our customizable traverse systems allow you to smoothly slide drapery out of the way.
By Product Line
Ireplaceable elegance. Classical Rodding, with or without rings
For Center open rods enter the size of each side (panel) then multiply result by two. This will ensure each panel has an even amount of carriers
Dimensions: 1 1/2'' L x 2'' H.
Dimensions: 1 1/2" Long x 2'' High
Ouverture is sold in pairs
A 2'' Kontur support is required to match this corner
A 4'' Kontur support is required to match this corner
A 6'' Kontur support is required to match this corner
Dimensions: 1/4" wide x 2'' High
A Kontur 2'' Support is required to match this finial
A Kontur 4'' Support is required to match this finial
A Kontur 6'' Support is required to match this finial
Kontur Evo rail inludes Clic carriers based on four carriers per rod foot and one 36'' wand.
Manual wood rails must be center open after 106'' as carriers will not traverse a splice.
Rails greater than 106'' will be shipped in two equal pieces to avoid high transport costs
Maximum number of characters: 225
Kontur Evo rail inludes Clic carriers based on four carriers per rod foot
Kontur 2'' supports, project 2 1/8'' from wall to pole
Back plate is 2'' in diameter
Kontur 4'' supports, project 4 1/8'' from wall to pole
Kontur 6'' supports, project 6 1/8'' from wall to pole
Kontur Ceiling Support is only available in three colors as it is hidden
80% Wave Drape™ carriers are used to create a smaller stack back but will reduce fullness, see Wave Claculator
For center open drapes please verify you have an even amount of carriers per panel
Full rolls are 500 carriers
Standard Wave carriers use industry spacing standard but fullness surpasses Snap Tape by 50%
Use Wave Snap Calculator to determine quantity of carriers
Front Load Snap Carriers are best used for commercial installations or when there are many rods
Snaps should be attached prior to installation at workroom to be best used
Clic carriers are included with your rod. Only order extra if four per rod foot is not enough.
Wave Drape™ Tape (Custom) is a service to allow you to order a precise quantity with no watse
This product is ordered in inches only
See Wave Calculator for your exact quantity based on fullness
Please note one 36'' wand is included with your manual rod
The Lance-rideau 48'' is made of aluminum with an anodized finish ensuring it will never tarnish
The Lance-rideau 60'' is made of aluminum with an anodized finish
The Lance-rideau 72'' is made of aluminum with an anodized finish
One End Stop is included with every manual rod. Only order extra for center open rods or for stock
One Center Cap is included with every Kontur Evo rod over 106''
Extra splices are used when covering a junction of two rods when surpassing 180''
* Required Fields
Real Wood with engineered lamination. Kontur Evo does not twist or bow in fluctuating humid conditions and is highly scratch resistant.
Rods greater than 106'' will be shipped in two equal pieces to avoid high transport costs